Silca Delta 2000 SA, Руководство по эксплуатации

Страница: 18 / 24

DELTA 2000 SA Operating manual - English
14 Copyright Silca 1998
U
SING THE BARS
The bars provided are used for cutting cruciform keys and as a tip rest for locking keys with no stop.
C
UTTING CRUCIFORM KEYS USING BARS
All types of cruciform keys (90˚) can be cut with the DELTA 2000 SA clamps and the aid of the bars.
Positioning cruciform keys:
1) leave the gauges in the idle position.
2) insert the bars into the slot in the clamps.
3) rest the tip of the keys against the bars (fig. 15).
4) secure the original key in the jaw.
5) remove the bar from the clamp to avoid contact with the tracer point or cutting tool.
6) repeat the same procedure, placing the key blank on the jaw.
7) cut the first side.
8) repeat the same procedure after turning the keys both in the same direction for the other cuts.
Fig. 15
T
IP STOP WITH A BAR
The bars can be used with keys which have no stop.
Proceed as follows:
1) leave the gauges in the idle position;
2) insert the bars into the slots in the clamps;
3) rest the tip of the key against the bar;
4) secure the key and remove the bar.