Silca Delta 2000 SA, Руководство по эксплуатации

Страница: 16 / 24

DELTA 2000 SA Operating manual - English
12 Copyright Silca 1998
6.3 Cutting operations
ATTENTION: to work in complete safety, pay special attention to the following recommendations:
• Always work with dry hands.
• Check that the machine is properly earthed.
• Use the protective goggles, even if the cutting tool is fitted with a protective shield.
• Start the motor only when all the operations with the carriage have been carried out
(securing keys, etc.).
• Keep hands away from the cutting tool when in motion.
6.4 Key cutting
Turn the clamps to find the appropriate side for securing the type of key to be cut (fig. 12)
1) loosen the knobs (A) by a couple of turns.
2) raise the lower part of the clamps and turn to the required position (fig. 12):
-
Side A: for keys to be fitted on their backs;
- Side B: for keys to be fitted on their backs which have cutting depths of less than 3,9 mm;
- Side C and D: for keys to be cut on both sides and locked on the groove.
S
ECURING THE KEYS IN THE JAWS
1) position the original key (left-hand jaw) and key blank (right-hand jaw), ensuring that:
a) the keys are positioned and secured as described in paragraph 6.4;
b) the key stop is resting against the calibration tabs (G);
2) secure the keys by closing the clamp with the knobs (A).
Fig. 12
A
B
C
D
A
B C
D
A
G