7
For Existing Hard Drives with Data
1.
As the BIOS boots press either
Ctrl+S
or
F4
when
prompted to enter the
RAID
BIOS.
2.
At the next screen select
Create RAID Set
, then
press
Enter
.
3.
At the next screen select
Mirrored
then press
Enter
.
4.
Select
Manual configuration
, then press
Enter
.
5.
Select the Source drive, press
Enter
.
6.
Select the Target drive, press
Enter
.
7.
At the
Disk Copy
window select
Yes
, then press
Enter
.
8.
Select
Offline copy
, then press
Enter
.
9.
When asked
Are You Sure (Y/N)?
, press
Y
to begin
disk copy.
Note:
Disk copy time is dependant on the size of the
mirrored set. Do not interrupt disk copy once
started.
10. After disk copy completes, press
Ctrl+E
to exit the
BIOS.
11. When asked
Are you sure to exit (Y/N)?
, press
Y
to
exit and reboot.
Rebuilding a Failed Mirror Set
When a failure to one member occurs, you will be notified
either by the RAID BIOS during boot or by the SATA Raid
GUI while in Windows. The steps below will guide you
in rebuilding a failed mirror set.
1.
Shutdown Windows, replace the failed hard drive,
then restart the system.
2.
During boot press either
Ctrl+S
or
F4
to enter the
RAID
BIOS.
Содержание Serial ATA PCI RAID
Страница 34: ...34 Blank Page ...
