SIIG Serial ATA 4-Channel PCI, Быстрое руководство по установке

Страница: 11 / 32

11
2. During boot press Ctrl+S or F4 to enter the RAID
BIOS.
3. Select Create RAID set then press Enter .
4. Select SPARE DRIVE then press Enter .
5. Select the replacement drive then press Enter .
6. When asked Are You Sure (Y/N)? , press Y to confirm.
7. Press Ctrl+E to exit.
8. When asked Are you sure to exit (Y/N)? , press Y to
exit.
Note: If during restart the RAID BIOS reports an
incomplete RAID set , disregard the message,
continue booting, and let the Mirror rebuild.
Single Drive Setup
Setting up a hard drive to operate as a single drive may
destroy all existing data on the hard drive, therefore, back
up any data on the hard drive before connecting it to the
RAID controller or use a blank or new hard drive.
1.
As the BIOS boots press Ctrl+S or F4 when prompted
to enter the RAID BIOS.
2. At the next screen select Create RAID Set , then
press Enter .
3. Select Concatenation , then press Enter .
4. Select 1 , then press Enter .
5. Select the hard drive, then press Enter .
6. When asked Are You Sure (Y/N)? , press Y to accept.
Note : In the RAID BIOS screen, under Logical Drive ,
SiI Concatenation and the size of the logical drive
will appear.
7. Press Ctrl+E to exit the BIOS.