-
13
-
Q
Q
Q
Q
Setting Roll Paper
This printer can be equipped with an optional paper holder to feed roll paper. Install
the paper holder, then set the paper.
CAUTION
Take care not to get your fingers caught in the printer when loading
paper.
(1) Insert the paper holder hooks into the upper
square holes on both sides of the platen
cover (shown 1 in figure). Push the paper
holder so that the paper holder tab is fit into
the lower square holes in the printer (shown 2
in figure). It clicks when the paper holder is
installed correctly.
(2) Turn the printer on.
(3) If the printer has been stored without setting
roll paper, open and close the platen cover (See
Section 2, Names of Parts) before setting the
roll paper.
(4) Turn the printer over, push the center of the
paper cover and slide it in the direction of the arrow.
The paper cover is unlocked and can be opened.
(5) Set the roll paper in the paper holder as shown in
the figure at the right. Insert the paper into the
paper slot of the printer until it stops.
When the printer detects the paper, it loads it
automatically. Close the paper cover and slide it in
the opposite direction of (3) until it clicks.
The paper cover is locked. To keep the paper
from falling out, fasten the paper cover
securely.
Paper holder
Paper cover
