SignWarehouse.com Bobcat BA-60, Руководство пользователя

Страница: 18 / 26

4-1
The cutting plotter communicates with a computer through a Parallel port (Centronics) or
a Serial port (RS-232C). This chapter shows you how to connect the cutting plotter to a
host computer and how to set up the computer/cutting plotter interconnection.
4.1 PARALLEL TRANSMISSION
4.1.1 Connecting to the Parallel Port (Centronics)
1. Connect the parallel cable to the cutting plotter and the host computer
(Figure 4-1).
2. Set up the output port LPT1 or LPT2 from your software package
3. Send the data to your cutting plotter directly. Or, use DOS commands like
TYPE or PRINT to output the data.
4.2 SERIAL TRANSMISSION
4.2.1 Connecting to the Serial Port (RS-232C)
1. For PC users, please connect the RS-232C cable to the serial connector of the
assigned serial port (COM1 or COM2) of your host computer.
2. Set up the communication parameters (Baud Rate, Data Bits/Parity and Stop Bits) to
match the settings on the computer.
CHAPTER 4 Connecting the Cutting Plotter