SIGNALCORE SC5312A, Руководство по эксплуатации и программированию

Страница: 16 / 32

SC5312A Operating & Programming Manual Rev 1.0.2 13
S
E T T I N G T H E
S C 5 3 1 2 A : W
R I T I N G T O
C
O N F I G U R A T I O N
R
E G I S T E R S
Configuration Registers
The users may write the configuration registers (write only) directly by calling the sc5312a_RegWrite
function. The syntax for this function is sc5312a_RegWrite(deviceHandle, registerCommand,
instructWord) . The instructWord takes a 64 bit-word. However, it will only send the required number of
bytes to the device. Table 2 summarizes the register addresses (commands) and the effective bytes of
command data.
Table 2. Configuration registers.
Register Name
Reg
Add
Serial
Range
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
INITIALIZE 0x01 [7:0] Mode
SET_SYSTEM_ACTIVE 0x02 [7:0]
Enable
SYS LED
RF_FREQUENCY 0x10
[7:0] MHz Frequency Word [7:0]
[15:8] MHz Frequency Word [15:8]
[23:16] MHz Frequency Word [23:16]
[31:24] MHz Frequency Word [31:24]
[39:32] MHz Frequency Word [39:32]
RF_AMPLIFIER 0x12 [7:0] Amplifier Mode
RF_ATTENUATION 0x13
[7:0] Attenuation
[15:8] Atten #
RF_PATH 0x14 [7:0] Path
RF_FILTER_SELECT 0x15 [7:0] Filter [3:0]
LO_FILTER_SELECT 0x16 [7:0] Filter [3:0]
LO_OUT_ENABLE 0x17 [7:0]
Enable
LO Out
IF_GAIN_DAC 0x18
[7:0] DAC value [5:0]
[15:8] Channel
VCOM_OUT_DAC 0x19
[7:0] DAC value [7:0]
[15:8] DAC value [13:8]
[23:16] Channel
DC_OFFSET_DAC 0x1A
[7:0] DAC value [7:0]
[15:8] DAC value [13:8]
[23:16] Channel
LINEARITY_DAC 0x1B
[7:0] DAC value [7:0]
[15:8] DAC value [13:8]
STORE_STARTUP_STATE 0x1D [7:0]
USER_EEPROM_WRITE 0x1F
[7:0] Address [7:0]
[15:8] Address [15:8]
[23:16] Byte[7:0]