-6-
Optional Wiring Connections:
ORANGE LEAD: (
Terminal 9)
–
Light Control Power Input:
If you will be
using the Light Control feature (instead off the Radio Repeat)
connect the Orange lead to the positive of the battery, or to a
high current power buss capable of supplying up to 20 amps of
power. Be sure to use minimum size #14 AWG wire.
Please Note: If you wish to use this feature you must leave the
“RAD” option jumper in place. (Refer to
Installer Selectable Options
section for jumper
details.)
WHITE w/ORANGE STRIPE: (
Terminal 8)
–
Light Control Power Output:
If
you will be using the Light Control feature (instead off the
Radio Repeat) connect the White w/Orange stripe wire to the
light(s) you wish to control (up to 20 amps). Be sure to use
minimum size #14 AWG wire.
Please Note: If you wish to use this feature you must leave the
“RAD” option jumper in place. (Refer to
Installer Selectable Options
section for jumper
details.)
BLUE LEADS: (
Terminals 3 & 6)
–
Radio
: Used for radio repeat. Connect
one blue lead to each terminal of the radio speaker or output
connector of the radio. Most radio outputs are isolated, in
which case polarity would not be important. Radios with
polarity sensitive outputs should be connected w/ the blue wire
from pin 6 to the positive radio output, and the blue wire from
pin 3 to the negative radio output. Use #18 AWG wire.
Please Note: If you wish to use this feature you must remove
the “RAD” option jumper. (Refer to
Installer
Selectable Options
section for jumper details.)
GREEN LEAD: (
Terminal 10)
- Used for remote Air Horn control. Connect to
the horn ring circuit or a remote switch. Circuit may be
positive or negative with proper jumper selection. (Refer to
Installer Selectable Options
section for jumper details.)
NOTE: Cut lead short if not used & insulate w/ electrical
tape.
Testing
- Test all of the functions after installation to assure proper operation. Test
vehicle operation to assure no damage to vehicle.
