-2-
Proper installation of the unit is essential for years of safe, reliable operation.
Please read all instruction
before
installing the unit. Failure to follow these
instructions can cause serious damage to the unit or vehicle and may void
warranties.
Qualifications -
The installer must have a firm knowledge of basic electricity,
vehicle electrical systems and emergency equipment.
Keep These Instructions
- Keep these instructions in the vehicle or other safe place
for future reference. Advise the vehicle operator of the location.
Unpacking
- Inspect contents for shipping damage. If found, alert carrier
immediately. Contents should include unit with microphone, mounting bracket w/ 2
bolts, microphone bracket with 2 screws, wiring harness with connector and these
instructions. Contact supplier immediately if any components are missing.
Installer Selectable Options
The LCS600 has several options that can be selected during installation. These
options include Positive or Negative auxiliary input activation of the Air Horn,
Standard or Alternate Air Horn Tone, and Light Control or Radio Repeat. Jumpers
on the printed circuit board, inside the case, allow the installer to select these
various options. These options should be set before installation of the unit.
Cover Removal
–
Remove the two Philips
head screws from the
front and the two from
the rear of the unit.
Slide the top cover up off of the top of the unit.
This cover can be removed completely from the
siren unit.
After the cover has been removed,
find the location of the option jumpers
(see the diagram to the right).
