.
92.
Block sand all edges to smooth out any rough areas.
93.
Remove the hatch and glue in a piece of
scrap 1/8" Lite-ply for the hatch hold-
down plate "HH" as indicated on the
plans. Drill through hatch for the 2-
56x1/2" hold-down screw.
94.
Glue a piece of scrap 1/32" plywood
(hatch tongue) to the front of the hatch
on the bottom side as indicated on the
plans.
95.
Drill the dowel holes on through the plywood doublers for the 5/32" wing hold-down dowels. It is best not to glue in the
dowels until after the model is covered. The fuselage may now be covered. Refer to the covering section.
TAIL CONSTRUCTION
96.
Use a modeling knife or jig saw to cut
the printed parts out of the 3/16" printed
balsa sheet. Be sure to cut just outside
of the lines.
97.
Sand the pieces down to the line with a
sanding block.
98.
Pin 5-1, 5-2, and S-3-in place over the
stabilizer plan.
99.
Glue and pin the 3/16"x1/4" leading and
trailing edge pieces in place over the
plan.
100.
Cut pieces of 1/8"x3/16" balsa for the
cross brace pieces.