.
69. Cut the jib tab off the bottom of the ribs.
70.
Glue and pin the 1/16"x1" trailing edge
bottom sheeting in place.
71.
Cut pieces of 1/16" sheeting (excess
from the fuselage sides) for the wing
center section and spread glue over the
ribs and along the spars.
72.
Pin the sheeting in place. The sheeting
will be flush with the tops of the spars.
73.
Finish sheeting the center section in the same manner.
74.
Trim the spars and trailing edge sheeting flush with the rib at each wing tip.
75.
Use a sanding block to finish the wing tip rib.
76.
Cut the wing tips WT from the 1/8" balsa printed sheet. Glue and pin in place.
77.
Use a sanding block to round the leading edge to airfoil shape.
78.
Sand the center section sheeting so that the sheeting is flush with the tops of the spars.
79.
Sand the rest of the wing lightly to smooth out any irregularities.
Page 10 of 14
Sig Hummer SIGRC50 Instruction Manual