SIG Antoinette 1909, Руководство пользователя, Страница: 13 / 30

.
53. After one set of wing mount tubes has been installed, repeat the same procedure
to install the wing mount tubes for the opposite wing panel.
54.
Glue the laser-cut plywood WM wing mounts in place over the front wing mount
tubes. You will have to use your hobby knife to angle the edges of the holes
slightly to allow the aluminum tubes to fit.
Set the wings aside until needed later.
TAIL SURFACES
55.
Cover the Stabilizer/Elevator plan with wax paper or plastic wrap for protection. Use 1/8" square balsa sticks and laser-cut
parts S1 and S2 to construct the Stabilizer directly over the drawing. When dry, unpin the Stabilizer from the plan and
lightly sand all the glue joints smooth.
Note: Remember to cut the longest pieces of 1/8" sq. balsa first, then the shorter pieces, in order to make the most
efficient use of the stock 36" long sticks.
56.
Use 1/8" square balsa sticks and laser-cut part CHG to construct the Elevator directly over the drawing. When dry, unpin
the Elevator from the plan and lightly sand all the glue joints smooth.
57.
58.
Cover the Fin/Rudder plan with wax paper or plastic wrap
for protection. Use 1/8" square balsa sticks to construct the
Fin directly over the drawing.
When dry, unpin the Fin from the plan and lightly sand all
the glue joints smooth.
Use 1/8" square balsa sticks and laser-cut part CHG to
construct the Rudder directly over the drawing.
When dry, unpin the Rudder from the plan and lightly sand
all the glue joints smooth.