Sifam Tinsley Theta 30P, Руководство по эксплуатации

Страница: 28 / 84

This screen allows the user to set the Start value of Input.
Pressing the “ Down” key will enter into the Start value edit” mode
Pressing “ Up” key will confirm the present value and then advance
to the Elbow function selection (section 3.1.8.3)
Start value can be set as follows :
1. 0 to 80% of end value for Apparent
Power Transducer
2. -100% to 80% of end value for
Active/Reactive Power Transducer
3. 0 to -175
º for Phase angle
Transducer. (Minimum span between
.
3.1.8.2: Start Value of Input
*
*
Editing Existing Start Value
Pressing the “ Down” key will scroll
the value of the first digit from
to 0 or it will get restricted by set
Pressing the “ Up” key will advance the operation to the next
digit and set the first digit, in this case to “0”.
(*Denotes that digit will be flashing).
0 to 4 and value will roll back again
End value of Input.
After gets it will first digit entered,
Pressing the “ Down” key will scroll
the value of the second digit from
to 0 or it will get restricted depending
prompt for second digit.
(*Denotes that digit will be flashing).
0 to 9, and value will roll back again
28
.
The band of the start value that can be set depends upon system type
& Transducer type selected.
4.-0.996 to 0.984 for Power factor Transducer.
End value and start value is 20 º )