Sierra Wireless AirLink FX100, Руководство пользователя

Страница: 83 / 114

4112221 Rev 7.2 June 19, 2013 83
User Guide Power Consumption
11.5.2.1. FX Series Configuration
The FX Series software configuration is performed by selecting the operating mode to use in
performing the measurement.
A description of the operating modes and the procedures used to change operating modes are given
in the appendix of documents [1] Open AT Application Framework AT Commands Interface Guide
and [2] AirPrime SL808xT and Q2698 Open AT Framework Commands Interface Guide.
Refer to the following list for the available operating modes of the FX Series:

Active Idle Mode

Sleep Idle Mode

Active Mode

Sleep Mode

Connected Mode

Transfer Mode class 8 (4Rx/1Tx) (in GPRS mode)

Transfer Mode class 10 (3Rx/2Tx) (in GPRS mode)

Transfer Mode class 12 (1Rx/4Tx) (in GPRS mode)
– for FX100 only

Transfer Mode class 8 (4Rx/1Tx) (in EDGE mode)

Transfer Mode class 10 (3Rx/2Tx) (in EDGE mode)

Transfer Mode class 12 (1Rx/4Tx) (in EDGE mode)
– for FX100 only

Connected Mode (in UMTS mode)
– for FX100 only

Data Transfer (in UMTS mode and HSxPA mode)
– for FX100 only
Note: The USB port must be deactivated to enter Sleep Mode.
11.5.2.2. Equipment Configuration
The communication tester is set according to the FX Series operating mode. Paging during idle
modes, Tx burst power, RF band and GSM/DCS/GPRS may be selected on the communication tester.
Refer to the following table for the network analyzer configuration according to operating mode.
Table 71. Operating Mode Information
Operating Mode Communication Tester Configuration
Alarm Mode N/A
Active Mode with GSM stack in Idle
Paging 9 (Rx burst occurrence ~2s)
Paging 2 (Rx burst occurrence ~0,5s)
Sleep Mode with GSM stack in Idle
Paging 9 (Rx burst occurrence ~2s)
Paging 2 (Rx burst occurrence ~0,5s)
Active Mode N/A
Sleep Mode N/A
Connected Mode
850/900 MHz
PCL5 (TX power 33dBm)
PCL19 (TX power 5dBm)
1800/1900 MHz
PCL0 (TX power 30dBm)
PCL15 (TX power 0dBm)