Siemens WTT563 Series, Инструкции по эксплуатации и монтажу

Страница: 33 / 124

EN EN
Siemens Building Technologies 2017-08-28 A6V10897697_----_b 33
(1) Remove the front cover of the housing by:
• Inserting the screwdriver in the right-hand slot and
pushing downwards to lever the cover open
• Inserting the screwdriver in the left-hand slot and
pushing downwards to lever the cover open
Installation
1
2
4
5 6
>
20
00
4
17
0
Install the device out of reach at a minimum installation height of
200 cm.
The following tools are necessary for correct installation:
• Slot-head screwdriver for simple opening of the housing cover
• Cross-head screwdriver or cordless screwdriver
• 5 mm stone drill bit for drilling the plug holes (5 mm) in the wall
(2) Remove the installation material
(4) Drill the four holes, each 170 mm apart
When drilling ensure you do not damage any utility pipes or cables
(electricity, water, IT network, etc) laid in the wall.
You should use at least 2, better 4 fixing points to fix the WTT563..
securely on the wall.
(5) Latch the 2 locking hooks of the front cover onto the locking webs of
the housing.
(6) Fold the front cover onto the housing.
(7) Latch in the cover audibly with a light pressure
(8) Seal the enclosed anti-tamper seal of
the gateway.
7 8
(3) Connect the two
battery cables to
one another.
3