Siemens Solaris CCDS1415-DN, Руководство по настройке, Страница: 15 / 74

15
Siemens Building Technologies
Fire Safety & Security Products 08.2006
8 Installation of the Dome unit
Before commencing use of the Solaris™ system, ensure the following has been
completed:
1. Ensure you have the correct tools to complete the installation, (see Section
8.1: Tools required).
2. Install the desired bracket in a suitable location, (see Sections 8.3.1 to 8.3.6).
3. Prepare the Dome bracket and attach it to the appropriate mounting bracket,
(see Sections 8.4: Preparing the Dome bracket and 0: Mounting the Dome
bracket to a wall mount ).
4. Assemble the Cat5 cable (see Section 8.5: Cat5 cable assembly and
disassembly).
5. Hook the Dome on to the hinge mechanism and connect the cable, clipping it
in place (ensure that it is correctly and firmly seated on the connector). Pull
the Dome into the vertical position (see Section 8.6: Connecting the Solaris™
Dome).
6. Check the bubble and ensure there are no scratches on the surface. If the
surface is marked, it may impair optical clarity.
7. Select a suitable location and mount the XTU, (see Sections 9.2.1: Choosing
a location for the XTU and 9.2.2: Mounting the XTU).
8. Connect the XTU to any external equipment, (see Section 9.3: Connecting the
XTU to external equipment).
9. If necessary, adjust the orientation of the XTU’s LCD display, (see Section
10.2: LCD orientation).
10. Configure the XTU to use the correct telemetry protocol and to identify itself
correctly, (see Section 10.3: The XTU main menu).
11. Setup the controller, (see Section 12: Telemetry controller operation and
setup and the controller’s installation and commissioning manual).
8.1 Tools required
Installing the Dome unit and the External Termination Unit requires only a basic
tool kit, including:
z
3 mm AF Allen key (supplied with ceiling mounting kit)
z
Medium sized Pozidrive screwdriver
z
Terminal screwdriver (flat-bladed)
z
RJ-45 crimping tool (only if custom Dome to XTU cable is used)
z
Suitable tools for chosen fasteners for fitting bracketry and mounting the XTU
z
Suitable tools to install the required cabling and connections
CAUTION
Handle the bubble of the Solaris™ Dome with extreme care and be sure not to
scratch it, as this may affect its optical clarity. If it is accidentally marked it may
be possible to remove small scratches or scuffs on the outer surface with the
use of a suitable cloth and metal polish (brass cleaner). However, if this is not
effective the bubble must be replaced.