Siemens sitrans PROBE LU, Быстрый старт, Страница: 7 / 184

7ML19985QV81 SITRANS Probe LU (PROFIBUS PA) – QUICK START MANUAL Page EN-5
m
mmmm
Englis
h
Mounting instructions
SITRANS Probe LU is available in three thread types: 2" NPT, 2" BSP, or PF2/G (BS EN ISO 228-1).
1.
Before inserting SITRANS Probe LU into its mounting connection, ensure that the threads
are of the same type to avoid damaging them.
2. Simply screw SITRANS Probe LU into the process connection and hand tighten.
Wiring
Power
1
Connecting SITRANS Probe LU (PROFIBUS PA)
1. Strip the cable jacket for approximately
70 mm (2.75") from the end of the PROFIBUS PA
cable, and thread the wires through the gland
2
.
2. Connect the wires to the terminal as shown:
Probe LU (PROFIBUS PA) is not polarity-sensitive.
Note:
Ideally, mount SITRANS Probe LU so that the face of the transducer is at least
300 mm (1 ft) above the highest anticipated level.
WARNINGS:
DC terminals shall be supplied from an SELV
1
source in accordance with
IEC-1010-1 Annex H.
All field wiring must have insulation suitable for rated voltages.
1.
Safety Extra Low Voltage
Note:
• For detailed wiring instructions, please see the full manual.
• For Intrinsically Safe setups (FM/CSA Class I, Div. 1), see
FM/CSA Intrinsically Safe
Connection Drawing
on page 1 of Appendix A, for drawing number 23650617.
• For Non-Incendive setups (FM: Class I, Div. 2), see
FM: Class I, Div. 2 Connection Drawing
on page 5 of Appendix A, for drawing number 23650583.
• The non-metallic enclosure does not provide a continuous ground path between conduit
connections: use grounding-type bushings and jumpers.
• Separate cables and conduits may be required to conform to standard instrumentation
wiring practices, or electrical codes.
2.
If cable is routed through conduit, use only approved suitable-size hubs for waterproof applications.
shield
wire