Siemens Sinumerik 810T, Руководство пользователя, Страница: 188 / 312

11.90 3 Operating Sequences
3.1.15 Data input/data output
Start the output of the R parameters by operating the
”START” softkey.
In the same way, you can select and start the output of data for the following:
– ”TOOL OFFSET”
– ”ZERO OFFSET”
– ”MACHINE DATA”
– ”PLC MACHINE DATA”
which have not been detailed here.
Using this softkey, you can stop data output at any time...
and continue it again with ”START”.
With the ”ETX-START” softkey you can output the end-
of-transmission character stored in the setting data.
The output is always made irrespective of whether RTS
line or Xon/Xoff protocol have been set.
or or
1
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
F
2
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
D
0
a a a a a a a a a a
a a a a a a a a a a
a a a a a a a a a a
a a a a a a a a a a
a a a a a a a a a a
a a a a a a a a a a
a a a a a a a a a a
a a a a a a a a a a
a a a a a a a a a a
S
START
STOP
ETX
START
Using the keyboard, enter the
channel no.:
into the input field marked in
inverse video:
”1” for output of local
R parameters, channel 1
”2” for output of local
R parameters, channel 2
”0” for output of the
global R parameters
a a a a a a a
a a a a a a a
a a a a a a a
a a a a a a a
a a a a a a a
Note:
• A selection of the data, i.e. the output of a section as with ”PART PROGRAM” - is not possible!
• The input of a channel no. is only required by the control for ”R PARAMETERS”.
• Data output with or without leader or trailer can be set via setting data (SD 5016, bit 1).
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
3-85
SINUMERIK 810T, GA3 (BN)