Connecting
3.3 Connecting the supply voltages
PDC1000(F)
Equipment Manual, 02/2020, A5E48775040-AA
25
Connecting of solid conductors and stranded conductors (stranded wire) with end sleeve
To connect a wire, proceed as follows:
1.
Strip 8 to 11 mm of insulation from the wires.
2.
Crimp the stranded conductors with end sleeves.
3.
Insert the wire into the spring-loaded terminal as far as it will go.
4.
Push the wired connection plug into the socket of the PDC.
5.
After connecting, check that the stranded wire or solid conductor cannot be pulled out
again.
Connecting of conductors: stranded, without end sleeve, unprocessed
To connect a wire without end sleeve, follow these steps:
1.
Strip 8 to 11 mm of insulation from the wires.
2.
Press the spring release with the screwdriver, and insert the wire into the spring-loaded
terminal as far as it will go.
3.
Let go of the spring release with the screwdriver.
4.
Push the wired connection plug into the socket of the PDC.
5.
After connecting, check that the stranded wire cannot be pulled out again.
Disconnecting a cable
Press the spring release as far as it will go with the screwdriver. Remove the wire.
Reference
Note the detailed information on the topic "Connecting" in the System Manual SIMATIC
MICRO-DRIVE Drive controller PDC
https://support.industry.siemens.com/cs/ww/en/view/109774126
Содержание SIMATIC MICRO-DRIVE PDC1000
Страница 1: ...PDC1000 F ...
