Expanding the device and assigning device parameters
6.2 Installing and removing a memory module
SIMATIC IPC477E
Operating Instructions, 11/2020, A5E37455003-AF
81
6.2
Installing and removing a memory module
The procedures for installing and removing the memory module are the same for all device
variants.
The motherboard is equipped with one slot for an SO-DIMM DDR4 memory module. You can
use it to expand the memory capacity of the device to a maximum of 16 GB.
Note
Use only the memory modules recommended by Siemens AG. You can find additional
information in the section "Accessories (Page 18)".
Requirements
•
The device is disconnected from the power supply.
•
The device is open.
Procedure
NOTICE
Note the protective measures required when working with ESD in the section "ESD guideline
(Page 111)".
Removal
1. Press the marked latches towards the
outside.
The memory module tilts forward.
2. Pull the memory module out of the slot in
the direction of the arrow.
