Configuring the operating system
6.6 Changing HMI device settings
Mobile Panel 277F IWLAN
154
Operating Instructions, 12/2007, A5E01003940-01
Procedure
Proceed as follows:
1.
Enter the interval in minutes after which the backlighting is to be reduced.
Entering "0" will deactivate the backlighting reduction.
2.
Enter the number of minutes before the screen saver is to be activated.
The minimum time is 5 minutes and the maximum time is 71582 minutes.
Entering "0" disables the screen saver.
3.
Select either the standard screen saver or an empty screen.
– In order to select the standard screen saver, select the "Standard" option.
– In order to select a blank screen as screen saver, select the "Blank Screen" option.
4.
Confirm your entries.
The dialog closes.
Result
The screen saver and the reduced backlighting for the HMI device is set. After you have
reselected the screen saver and reduction of the backlighting, you must restart the HMI
device. The selection becomes effective following a restart.
See also
Power management (Page 98)
Restarting the HMI device (Page 156)
6.6.6
Changing the printer properties
Introduction
You can print hardcopies and reports on a network printer. Line printing of alarms is not
possible on a network printer.
The list of current printers and required settings for HMI devices can be found on the Internet
under "http://support.automation.siemens.com/WW/view/en/11376409".
Requirements
You have opened the "Printer Properties" dialog with the "Printer"
icon.
