7KT PAC1200 multichannel current measuring system
System Manual, 11/2016, 2514374103-02
55
Service and maintenance
6
6.1
Error messages
The Status LED does not light up
Problem: The Data Manager is not supplied with power.
Solution: Ensure that at least the line conductor L1 and the neutral conductor N are
connected to the Data Manager.
The Status LED lights up or flashes red.
Problem: There is a fault.
Solution: Restart Data Manager.
Solution: Contact Service.
The network LED does not light up, or the Data Manager is not found in the network.
Problem: The network cable is not correctly connected to the network connection.
Solution: Ensure that the network cable is correctly connected to the network connection.
Problem: The Data Manager is not located in the same local network.
Solution: Connect the Data Manager with the same router / switch, or change the IP address
in the PC.
The Energy Manager supplies unrealistic measured values.
Problem: The Data Manager has been installed incorrectly.
Solution: Check connection of L1 to L3 again.
6.2
Disposal
The system must be disposed of in accordance with the locally applicable regulations for the
disposal of electronic waste.