Safety notes
2.1 Safety instructions
7KT PAC1200 multichannel current measuring system
10
System Manual, 11/2016, 2514374103-02
NOTICE
Damage to, or destruction of, the Data Manager. Material damage.
Do not connect an ISDN cable to the Data Manager’s network connection.
Use the multichannel current measuring system in dry environments only and keep away
from liquids.
Note
Install the multichannel current measuring system in the control cabinet only, and ensure that
the connection areas for the line conductor and the neutral conductor are located behind a
cover or touch protection barrier.
Do not operate the Data Manager beyond the limits specified in the technical data.
The enclosures or electrical distribution boards must only be accessible using a key or tool to
restrict access to authorized personnel. Disconnect the electrical distribution board before
installation work or maintenance work, and protect it from being unintentionally switched on
again.
Note
You can find the open-source software included in this product, and the corresponding open-
source software license conditions, in the Readme_OSS.
Data Manager
For safety reasons, it is forbidden to modify the product, including the software, or to install
components that are not expressly recommended or marketed for this product.
Any use of the product other than the intended use described is considered improper use.
Impermissible modification, conversions, repairs, or opening of the product are forbidden.
The enclosed documentation is a component part of the product and must be read,
observed, and kept available at all times.
In accordance with its classification in Overvoltage category III, the Data Manager may only
be connected in the subdistribution board or circuit distribution board on the load side
downstream of the energy counter of the power supply company. It is suitable only for use in
the indoor area, and it is approved for use in the member states of the EU. Use the sensor
bar only in accordance with the information given in the enclosed documentation. Any other
use can result in material damage and personal injury.
The Data Manager is not an electricity meter for active-power consumption in the sense of
EU Directive 2004/22/EC (MID). It must only be used for internal accounting purposes. The
data collected by the Data Manager about power generation in your plant can differ from the
data of the main energy counter.