Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
or
cli#
Syntax
Call up the command with the following parameters:
show lacp [<port-channel(1-8)>]{counters|neighbor[detail]}
The parameters have the following meaning:
Parameter
Description
Range of values / note
port-channel
Number of the Channel-Group
1 ... 8
counters
Shows the values of the counters
-
neighbor
Displays information on neighbor ports -
detail
Displays detailed information on neigh‐
bor ports
-
If you do not select a port channel, information for all available interfaces is displayed.
Result
The information is displayed.
6.2.2
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface
command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit
command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the
end
command, you return to the
Privileged EXEC mode.
6.2.2.1
channel-group
Description
With this command, you add an interface to an Etherchannel.
Network structures
6.2 Link aggregation
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
215