Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
264
Configuration Manual, 11/2014, C79000-G8976-C351-03
7.1.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal
command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end
or
exit
command and are then in the
Privileged EXEC mode again.
7.1.2.1
telnet-server
Description
With this command, you enable the Telnet server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
telnet-server
As default the function is "enabled".
Result
The Telnet server is enabled.
Further notes
You disable the Telnet server with the
no telnet-server
command.