System time
5.3 SNTP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
114
Configuration Manual, 11/2014, C79000-G8976-C351-03
Further notes
You can reset the setting to the default with the
no sntp unicast-server
command.
You display this setting and other information with the
show sntp unicast–mode status
command.
5.3.5.3
no sntp unicast-server
Description
With this command, you delete the attributes for an SNTP unicast server and reset the
address.
Requirement
You are in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
no sntp unicast-server {ipv4 <ucast_addr> | fqdn-name <FQDN(100)>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
ipv4
Keyword for an IP address
-
ucast_addr
Value for an IPv4 unicast address
Enter a valid IPv4 unicast address
fqdn-name
Keyword for a domain name
-
FQDN(100)
Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
Result
The SNTP unicast server is reset to the default value.
Further notes
You configure the setting with the
sntp unicast-server ipv4
command.
You display this setting and other information with the
show sntp unicast–mode status
command.