8
Smart Infrastructure
A6V11986596_en--_e
Building Products
2022-04-27
Position and function of the operating and display elements
Fig. 3: Control and display elements, example: Solar protection actuator N 543D51, 8 x 6 A
Pos. Operating or display elements
Function
1 Programming LED (red),
Programming button
Short push of button (< 2 s):
●
Activate programming mode, display status (LED on = act-
ive).
Very long push of button (> 20 s):
●
Reset to factory settings (after 20 s, the LED starts flashing
for about 8 s).
2 Button: Deactivate direct operation
Short key press:
●
Deactivate direct operation for all channels.
Pressing the key and pressing the Stop/Slat Up/Down key (4, 6)
of a channel:
●
Deactivate the direct operation of the respective channel.
3 Status LED of direct operation (yellow) LED flashes if direct operation is active for at least one channel.
4 Button: Stop/slat:
“Up” move command of the channel
Short press of button (< 1 s):
●
Move command “Stop” or “Lower”
●
Activate direct operation for the channel.
Long push of button (> 1 s):
●
Move command “Down” active
●
Activate direct operation for the channel.
5 Status LED of the channel, below (red) Indicates the status of the respective channel.
●
LED switched off: Direct operation is switched off.
●
LED lit: Move command “Down” active.
●
LED flashing in sync with status LED: Direct operation is
switched on.
