Siemens HR976GM.1, Руководство пользователя и инструкции по установке

Страница: 17 / 52

Steaming
en
17
3.
Lift the water tank and remove it from the water tank
recess ​⁠.
4.
Press down on the water tank lid along the seal to
prevent water from leaking out of the water tank.
5.
Remove the cover ​⁠ on the water tank.
6. Fill the water tank with water up to the "max" ​⁠
mark.
7. Put the cover back into the opening on the water
tank.
8. Slide the full water tank back into the recess ​⁠.
When doing so, make sure that the water tank clicks
into place in the retainers ​⁠.
9. Slowly slide the control panel downwards and then
push it away from you until it is closed completely.
11.2 Setting options with steam
There are various ways in which you can prepare your
food with steam.
Added steam
When you cook with added steam, the appliance intro-
duces steam into the cooking compartment at various
intervals. This gives your food a crispy crust and a
shiny surface. Meat stays juicy and tender, and only un-
dergoes a minimum reduction in volume.
You can combine added steam with the following
functions:
¡
Types of heating → Page 14
– 4D hot air ​⁠
– Top/bottom heating ​⁠
– Circulated air grilling ​⁠
– Keeping warm ​⁠
¡
Dishes → Page 21
¡
Meat probe →
Page 19
Steam jet
You can use the steam jet function to specifically add
intensive steam at various intervals. This makes bread
and bread rolls in particular wonderfully crispy and
gives them a golden colour.
The appliance adds clouds of steam to the cooking
compartment for approx. 3 to 5 minutes. Depending on
the operation, you can activate the steam jet several
times.
You can add the steam jet for the following functions:
¡
Types of heating → Page 14
– 4D hot air ​⁠
– Top/bottom heating ​⁠
– Circulated air grilling ​⁠
¡
Meat probe →
Page 19
Note: Only use the steam jet when cooking compart-
ment temperatures are above 120 °C.
11.3 Setting the type of steam heating
Note:
Observe the instructions for the types of steam heating:
¡
Requirement: The water tank has been filled. If the wa-
ter tank runs dry during operation, a message appears
on the display. Operation is stopped.
→ "Filling the water tank", Page 16
1. Press "Steam".
2. Press the required type of steam heating.
3. Set the temperature using ​⁠ or ​⁠, or via the adjust-
ment bar. Or enter the cooking time directly via the
number field ​⁠.
4. Press "Cooking time".
A cooking time must always be set for types of
steam heating.
5. To change the preset cooking time, press the relev-
ant time value, e.g. minute display "min" or second
display "s".
a
The selected value is marked in blue.
6. Set the cooking time using ​⁠ or ​⁠, or via the adjust-
ment bar. Or enter the cooking time directly via the
number field ​⁠.
If required, use ​⁠ to reset the adjustment value.
7. Press "Apply".
8. Use ​⁠ to start the operation.
a
The appliance starts to heat and the time counts
down.
a
When the time has elapsed, a signal tone sounds. A
message appears on the display confirming that the
operation has finished.
9. Once the cooking time has elapsed:
‒
If required, you can select other settings and re-
start the operation.
‒
When the food is ready, use ​⁠ to switch the ap-
pliance off.