Siemens HB676GB.1, Инструкция по эксплуатации

Страница: 24 / 49

Trouble shooting
en
23
1.
Insert the intermediate panel at the bottom into the
retainer and push it in firmly at the top (figure
!
).
2.
Push both retainers downwards (figure
"
).
3.
Insert the front panel at the bottom into the retainers
(figure
#
).
4.
Close the front panel until both upper hooks are
opposite the opening (figure
$
).
5.
Press the front panel at the bottom until it clicks
audibly into place (figure
%
).
6.
Open the appliance door again slightly and remove
the tea towel.
7.
Screw both screws back in on the left and right.
8.
Put the cover back in place and press on it until it
clicks audibly into place (figure
&
).
9.
Close the appliance door.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
3
Trouble shooting
Trouble s hooting
If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Note:
If a dish does not turn out as well as you had
hoped, refer to the table section at the end of the
instruction manual, where you will find plenty of tips and
information.
~
"Tested for you in our cooking studio"
on page 26
:
Warning
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault table
If an error message beginning with 'E' is shown, e.g.
E0111, switch the appliance off and then on again. If
this message appears again, contact the after-sales
service.
--------
2 1
Fault Possible cause Information/remedial action
The appliance does not work The fuse is faulty Check in the fuse box to make sure that the fuse for
the appliance is in working order
Power cut Check whether other kitchen appliances are working
The appliance door will not open; the
5 symbol is shown in the display
The appliance door is locked until the cooking com-
partment has cooled down.
Wait until the 5 symbol goes out
Although the appliance is switched
on, it cannot be operated; the 1
symbol is shown in the display
The child lock is activated
Press and hold the 1 button until the 1 symbol
goes out
The cooking compartment does not
heat and "Demo mode on" is shown in
the display
The appliance is in demo mode Switch off the fuse in the fuse box and switch it back
on again after approx. 10 seconds. Switch on the
appliance and select "Demo mode off" in the settings.