Getting started
16
M56 Barracuda long, am english, A31008-H6350-A40-1-4A19 (28. July 2003,
©
Siem
ens A
G
2001
, I
:\Mob
il\L55\M
56_Barracuda\fug\Anlief
erung_22070
3\M56_
Startup.fm
Charge battery
The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a mains
power socket and charge for at
least
two hours
.
Display when charging is in progress
;
During charging.
Charging time
An empty battery is fully charged
after about 2 hours. Charging is only
possible within a temperature range
of +41 °F–104 °F. If the temperature
rises/falls 41 °F above/below this, the
charge symbol flashes a warning.
The mains voltage specified on the
power supply unit must not be
exceeded.
Charge symbol not visible
If the battery has been discharged
fully the charge icon is not visible
when the charger is plugged in. It
will appear after up to two hours. In
this case the battery is fully charged
after 3–4 hours.
Only use the charger provided!
Display while in service
Charge level display during opera-
tion (empty-full):
4 7 :
A beep sounds when the battery is
nearly empty. The battery level is
only shown correctly during an
unbroken charging/discharging
cycle. You should therefore
not
remove the battery unnecessarily
and
where possible
not finish the charging
process early
.
pq
rs
tuv
w
xyz
jk
l
ab
c
ghi
m
4
7
8
5
2
6
9
0
Additional information
The charger heats up when used for long
periods. This is normal and not dangerous.
Operating time.................................p. 118
Outside your home network ............p. 118
Note
Your phone's display is delivered with a protective film.
Remove this film before getting started
.
Electrostatic charging can in rare cases lead to discoloring at the edge of the display. This
will, however, disappear of its own accord after 10 minutes at the most.