30
Appendix
Gigaset C185 / CAN usengl / A31008-M1972-R401-1-5819 / appendix.fm / 24.6.09
Appendix
Care
Wipe the base station and handset with a
damp
cloth (do not use solvents) or an
antistatic cloth.
Never
use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1.
Immediately switch the handset off
and remove the batteries.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the hand-
set, with the battery compartment
open and the keypad facing down in a
dry, warm place
for at least 72 hours
(not in a microwave oven, convection
oven, etc.).
4.
Do not switch on the handset again
until it has completely dried.
When it has fully dried, you should be able
to use it again normally.
Questions and answers
If you have any questions about the use of
your telephone, you can contact us any
time at
www.gigaset.com/customercare
The table below (page 30) contains a list
of common problems and possible solu-
tions.
Troubleshooting
!
The display is blank.
1. The handset is not switched on.
¥
Press
a
and hold the End Call key.
2. The batteries are empty.
¥
Charge or replace the batteries (page 8).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and
hold
the pound key
#
Base Search
and
Ä
is flashing on the display
screen.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
Please
Register
is flashing on the display screen.
¥
Register the handset (page 24).
3. The base station is not switched on.
¥
Check the base station power cord
Handset does not ring.
The ring tone is switched off.
¥
Activate the ring tone (page 27).
You cannot hear the ring/dialing tone.
Base station's phone cord has been replaced.
¥
When purchasing a new cord, make sure
that it has the correct pin connections.
¥
Correct phone jack assignment.
3
2
1
4
5
6
1 unused
2 unused
3 a
4 b
5 unused
6 unused
