Siemens FIDAMAT 6, Руководство по эксплуатации, Страница: 131 / 202

Functions
8.6 Configuration
FIDAMAT 6
Operating Instructions, 01/2019, A5E00222135-04
129
Figure 8-66 Change start-up state/operating state (FIDAMAT 6-G)
This function can be used to set the device to different start-up states.
Standby (FIDAMAT 6-E only)
The pump is switched off with this setting. When this state is exited, the pump is started and
the device goes to 'Measuring' state. This setting serves to reduce usage of the pump
without interrupting the process.
Pause
With this setting, you reduce the gas consumption by switching off the pump. This state is
exited via the warm-up phase.
Pause without heating
With this setting, you reduce the gas consumption and power. In addition to the pump, the
heating is also switched off. This state is exited via the warm-up phase.
Sample gas/ standby (FIDAMAT 6-G only)
With this setting you select whether the sample gas valve remains open in standby state.
This enables a change from standby to measuring state with a pressure increase of the
applied sample gas. This setting is available starting in firmware V1.3.5.
Note
Change of operating state
The operating state can be changed manually using function 91 or automatically as a result
of faults/maintenance requests. You will find the possible state changes in table "Change of
state due to fault/maintenance request" in section State change due to fault / maintenance
request (Page 62).