Siemens ET375MU11E, Инструкция по эксплуатации

Страница: 16 / 60

16
3.
To grill with lava stones: Remove the lava stones from the
packaging and place them in the lava stone container. Insert
the lava stone container in the appliance.
4.
Fold down the grill element, replace the wire rack.
The grill is ready for operation.
Setting the grill
In this section, you can find out how to set the grill.The table
shows grill settings and cooking times for various meals.
Switching the grill on and off
Use the main switch to switch the grill on and off.
To switch on: touch the
#
symbol. An audible signal sounds.
The indicator above the main switch lights up. The grill is ready
for operation.
Switching off: touch the
#
symbol until the indicator above the
main switch goes out. The grill is switched off. The residual heat
indicator remains on until the grill has cooled down sufficiently.
Note: The grill switches off automatically if the grill setting is set
to 0 for more than 20 seconds.
Setting the grill
Set the desired grill setting on the control panel.
Grill setting 1 = lowest output
Grill setting 9 = highest output
Setting the grill setting
1. Switch the grill on using the main switch.
‹
and the
N
symbol light up in the grill setting display.
2.
Slide your finger along the settings range until the desired
grill setting appears on the display.
Note: The grill is regulated by the grill element being switched
on and off. Even at maximum power, the grill element can
switch on and off.
Preheating the grill
Only place food on the grill when the preheating time has
elapsed. The preheating symbol goes out. During the
preheating time, the grill heats up at full power. Thereafter, the
temperature is reduced by the heating elements being switched
on and off in order to maintain a constant temperature for the
respective setting.
The preheating time can be between 8 and 10 minutes,
depending on the grill setting.
Note: Preheat the empty grill for a maximum of 8-12 minutes. A
longer preheating time could result in the appliance switching
off (overheating protection). Switch the appliance off and leave
it to cool down before switching it on again.
Topping up the water
If there is too little water in the grill container, the overheating
protection switches the appliance off. Therefore, while grilling,
monitor the water level in the grill container and top it up as
necessary.
Grilling with lava stones: bottom mark
Grilling without lava stones: top mark
ã=
Risk of scalding!
If water touches the hot wire grilling rack or grill element during
topping up, hot steam will be generated. Do not reach over the
grill while topping up and do not pour water over the hot
components.