Siemens ET375MU11E, Инструкция по эксплуатации

Страница: 19 / 60

19
Do not use these cleaning agents
■
Scouring or chemically aggressive cleaners
■
Acidic cleaners (e.g. vinegar, citric acid, etc)
■
Cleaners containing chlorine or with a high content of alcohol
■
Oven cleaner
■
Hard and scratchy sponges, brushes or scouring pads
■
Thoroughly wash out new sponge cloths before using them.
Rectifying faults
Malfunctions often have simple explanations. Please read the
following notes before calling the after ­ sales service.
Appliance part/
surface
Recommended cleaning
Wire grilling rack Remove rough residues with a wash-
ing-up brush. Soak the wire rack in the
sink. Clean with a washing-up brush
and washing-up liquid and dry thor-
oughly.
Brush stubborn dirt with our grill
cleaner gel (order no. 463582) and
leave to act for at least 2 hours, or
overnight in severe cases. Then rinse
thoroughly and dry. Note the packag-
ing instructions of the cleaner.
Do not clean in the dishwasher!
Lava stone tray
and grill container Remove lava stones or drain water.
Clean in the sink with water and wash-
ing-up liquid using a washing-up brush;
dry with a soft cloth. Leave stubborn
dirt to soak or remove with our grill
cleaner gel (order no. 463582).
Lava stones Dry very damp lava stones occasion-
ally in the oven at 200°C. This can
help prevent the formation of mould.
Replace lava stones when they
become black. The lava stones may
be fully saturated with fat and could
generate a lot of smoke during use or
the fat could catch fire.
You can obtain the correct lava stones
from your specialist retailer (order no.
LV 030 000). When topping up,
ensure that the grill element does not
lie directly on top of the lava stones.
Control panel and
glass ceramic
cover
Clean with a soft, damp cloth and
some washing-up liquid; the cloth
should not be too wet. Dry off with a
soft cloth.
Appliance part/
surface
Recommended cleaning
Display Fault Measure
Blank There is no power supply. Check the household fuse for the appliance. Check whether there is a
power cut by trying other electronic appliances.
“
is flashing
The control panel is damp or an object
is resting on it.
Dry the control panel or remove the object.Then touch any control.
Ҥ
+ number
Appliance fault Switch the appliance off and on again. Contact the after-sales service if
this appears in the display again.
”…
The electronics have overheated and
have switched the appliance off.
Wait until the electronics have cooled down sufficiently. Then touch any
control.
”‰
The appliance was in operation for too
long and has switched itself off.
You can switch the grill back on again immediately.
The appliance
has reduced
power or
switched off.
Excessive preheating. Preheat the empty grill for a maximum of 8-12 minutes. A longer preheat-
ing time could result in the appliance switching off (overheating protec-
tion). Switch the appliance off and let it cool down.