Siemens CD634GB 2W Series, Инструкция по эксплуатации

Страница: 22 / 32

en
Cleaning
22
3.
Remove the cover (figure
"
).
4.
Loosen and remove the screws on the left and right
of the appliance door (figure
#
).
5.
Before closing the door again, trap a tea towel which
has been folded several times in the door (figure
$
).
Pull out the front panel upwards and lay it on a flat
surface with the door handle facing downwards.
Clean the panels with glass cleaner and a soft cloth.
:
Warning
Risk of injury!
■
Scratched glass in the appliance door may develop
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
Risk of injury!
■
The hinges on the appliance door move when
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Fitting the door on the appliance
1.
Insert the front panel at the bottom into the retainers
(figure
!
).
2.
Close the front panel until both upper hooks are
opposite the opening (figure
"
).
3.
Press the front panel at the bottom until it clicks
audibly into place (figure
#
)
4.
Open the appliance door again slightly and remove
the tea towel.
5.
Screw both screws back in on the left and right.
6.
Put the cover back in place and press on it until it
clicks audibly into place (figure
$
).
7.
Close the appliance door.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
Cleaning the rails
The rails can be removed for cleaning.
:
Warning – Risk of burning due to hot components
in the cooking compartment!
Wait until the cooking compartment has cooled down.
Detaching the rails
Note:
Swing the front of the rail as far as possible (until
you feel resistance), otherwise the appliance side panel
may become bent.
1.
Carefully press the front of the rail upwards until it
becomes detached, and release it from the holder at
the side (fig.
!
).
2.
Detach the rail from the holder and remove it (fig.
"
).
3.
Clean the rails with washing-up liquid and a sponge/
brush
or
Clean the rails in the dishwasher.
Attaching the rails
1.
Position the rail so that the indentations are facing
upwards.
2.
Hook the rail in at the back and push it towards the
rear until it engages (fig.
#
).
2 1
2 1
2 1