Siemens CCDA1445, Руководство по установке, Страница: 30 / 342

Installation
30
Building Technologies
048_CCDA1445_A6V10257135_V1.0_en
Fire Safety & Security Products 20.08.2009
TO AN AC OUTLET
POWER(AC 24V)
AC ADAPTOR
ALARM OUT
MONITOR
CONTROL PANEL
BNC
ALARM IN
GROUND
RS 485
VIDEO IN
Da
ta
-
VIDEO OUT A
la
rm IN
4
A
la
rm IN
3
A
la
rm IN
2
A
la
rm IN
1
Da
ta
+
TO HOUSING
GND ~AC 24V~
NC
CO
M
NO
GN
D
Wiring of conjunction box
1. Paste the template on the wall.
2. Drill 4 holes into the wall with Ø ⅜” (9.5 mm), depth 1½” (40 mm).
3. Use a hammer to put an expansion anchor into each hole just drilled.
4. Attach the wall mount with junction box to the wall, then fasten the 4 hexagon
head nuts securely.
5. Open the junction box by loosening all the screws on the junction box (except
the marked one) using the special hexagon driver included.
6. Feed the field-cables through the plastic cable gland, which is assembled on
the bottom of junction box, then, tighten the cable gland by rotate it to make it
waterproofed.
7. Pull the rubber cap onto the mount pipe.
8. Attach an outdoor housing to the wall mount with junction box.
9. Use an Allen key to fasten the fixing screw to prevent the outdoor housing from
falling.
10. Fix the safety wire of the outdoor dome housing to the mount using the safety
wire screw.
11. Place the rubber cap in the proper position.
12. Connect the dome cables to the junction board using the system-cable that is
delivered together with the weatherproof-housing.
13. Connect the cables from appliances to the junction board as shown.