System
unit
Plastic drive covers with studs
Remove the front cover as described in see "Opening the system unit".
1
2
Release the clamps on the corresponding metal plate (1).
Remove the metal plate (2).
!
Do not throw the metal plate away. If you install a hard disk drive, you must
insert the metal plate again.
Make the appropriate settings for the drive.
1
2
Push the drive into the drive chassis (1).
Fasten the drive with the four screws (2).
A26361-K381-Z129-3-7619
29
System unit
If you install a second floppy disk drive, you must replace the data line for
i
the standard 3 1/2 inch floppy disk drive with the data line supplied with the
second floppy disk drive. The data line connector for the 3 1/2 inch floppy
disk drive is designated A and the connector for the second floppy disk drive
is designated B.
If you install a second IDE hard disk drive, you must replace the data line for
the standard hard disk drive with the data line supplied with the second hard
disk drive. The data line connector for the standard hard disk drive is
designated C and the connector for the second floppy disk drive is
designated D.
Connect the data line and the power supply line to the drive.
If you install an accessible drive, you must remove the corresponding plastic
i
drive cover on the front cover.
Cut the ties of the plastic drive cover on the front cover and remove it.
30
A26361-K381-Z129-3-7619