System
unit
1
2
Fasten the additional angle bracket with the screw at the module (1 and 2).
2
1
Refit the rear slot cover plate (1) with the screw previously removed.
If you loosened the screws on the adjoining cover plates, tighten them again (2).
Connect the lines removed before.
Refit the top cover as described in "Assembling the system unit".
A26361-K381-Z129-3-7619
21
System unit
Installing and removing a drive
The system unit includes as standard a 3 1/2 inch floppy disk drive and a hard disk
drive. You can also install two accessible drives.
Changing the floppy disk drive
Remove the top cover and the drive carrier as described in "Opening the system
unit".
1
2
Remove the four screws that secure the floppy disk drive to the carrier (1).
Slide the floppy disk drive out of the drive carrier (2).
If a cover plate is fitted at the floppy disk drive, you must remove it and
i
attach it to the new drive.
1
2
Remove the two screws (1) and the cover plate (2).
22
A26361-K381-Z129-3-7619
