Menu Server
Settings in BIOS Setup
A26361-D970-Z120-3-7619
45
VT100 Mode
Requirement:
Enabled
must be set in the field
VT100
.
Defines whether communication with the terminal is stopped before the operating
system is started. Communication with the terminal is not possible once the
operating system has been started, until a suitable operating system driver sets the
communication up again.
Standard
The system BIOS stops communication with the terminal before
the operating system is started. The area in main memory used for
communicating with the terminal is then fully available to the
operating system again (default entry).
Enhanced
Communication with the terminal is not stopped before the
operating system is started. Use this setting if you want to start the
operating system via a selection menu from the terminal. After the
operating system has been selected and started, it generally stops
communication with the terminal. The area in main memory used
for communication with the terminal may, however, no longer be
available to the operating system.
VT100 Interface Addr. - VT100-address
Requirement:
Enabled
must be set in the field
VT100
.
Defines the I/O address for communication with the terminal.
3F8h, 2F8h, 3E8h, 2E8h
The specified I/O address is used for communication with the
terminal. The serial port at which the terminal or modem is
connected must be set to the same address (default entry:
3F8h).
VT100 IRQ
Requirement:
Enabled
must be set in the field
VT100
.
Defines the interrupt for communication with the terminal.
IRQ3, IRQ4, IRQ5, IRQ6, IRQ7
The specified IRQ is used for communication with the terminal.
The serial port at which the terminal or modem is connected must
be set to the same IRQ (default entry:
IRQ4
)
.
Содержание D970
