Add-on modules
2
3
4
5
6
7
11
10
12
9
1
8
1 = Connector remote power-on
7 = Socket for processor
2 = Connector 2 for
8 = Location for voltage converter
IDE drives 3 and 4
9 = Imageport Connector
3 = Location bank 1 for main memory
10 = Socket for video memory
4 = Location bank 0 for main memory
11 = Lithium battery
5 = Connector for external
12 = Connector for external
loudspeaker
monitor controller
6 = Connector for processor fan
(VESA VGA pass through)
Upgrading main memory
Four locations (bank 0 and bank 1) are available on the system board for installing
memory modules. The board supports a maximum of 128 Mbytes. You may use
memory modules of 4, 8, 16 or 32 Mbyte.
If you wish to add or remove memory modules, you may have to remove the disk-
drive mount (see your PC's technical manual).
!
You may only use fast memory modules (access time = 70ns or less).
You must always add memory modules in pairs. In other words, you fit the
first pair to bank 0, and the second pair in bank 1. Pairs of memory modules
must have the same capacity and the same access time.
A26361-D842-Z120-6-7619
37
Add-on modules
Installing memory modules
2
1
Insert the memory module at an angle into the appropriate location (1).
Ensure that the key notch and the two holes are correctly aligned with the
retaining pins.
Tilt the module down until it snaps into place (2).
Removing a memory module
2
1
1
3
Carefully push the retaining clips at each end of the module outwards (1).
Tilt the memory module forwards (2), and pull it upwards and at an angle out of
the mounting location (3).
38
A26361-D842-Z120-6-7619
