16
AEROVITAL
Original operating instructions
06.2018
Basic functions
• The infrared receiver receives the signals of the remote
control and transmits these to the unit control.
• The switched air throughput levels are indicated by the
corresponding number of bars in the display.
• When it is switched on, the AEROVITAL always starts in
program P1 (pollen protection program).
After a voltage failure (e. g. power failure), the
AEROVITAL automatically starts in the program that was
last used (P1, P2 or P3).
• During the initial commissioning, the AEROVITAL starts in
air throughput level 5 (factory setting).
Later, the unit will start at the most recent set air flow level
when switched on.
AEROVITAL
Infrared
receiver
Button
Buttons on the unit
The required air throughput level can be adjusted by pressing the button briefly.
Unit is switched off
Air throughput level 1
Air throughput level 4
Air throughput level 10
Humidity control
Remote control
The required function can be carried out by pressing the corresponding button briefly.
Button Function
Comments
Switch on unit
• Unit always starts in pollen protection program P1
Switch off unit
• Ventilation unit off
Increase air throughput level
• The amount of air is increased in increments (max.
level 10)
• Function is only available in program P1
Increase desired air humidity or room temperature and
basic ventilation level
• Function is only available in program P2 and P3
Reduce air throughput level
• The amount of air is reduced in increments (min.
level 1)
• Function is only available in program P1
Reduce desired air humidity or room temperature and
basic ventilation level
• Function is only available in program P2 and P3
