2
Safety information
2.1
Intended use
The RMS3xx radar sensor is used for area monitoring. Within a defined detection area,
the sensor detects static and moving objects, and triggers a switching signal upon
detection of a corresponding object.
Distance zones can be defined and these zones can be assigned various functions.
The distance of the objects, the speed and the direction of the movement within the
detection area are calculated and provided via the data telegram.
All object data can be provided via Ethernet. The ability to provide it via the CAN
protocol is in the planning stages.
The SOPAS ET software from SICK AG must be used to operate the RMS3xx.
NOTE
The radar sensor is approved for operation in countries listed in the RMS3xx “Regula‐
tory Notes” technical information (no. 8021596). This document is included with the
device. The operation of the device in other countries can interfere with protected
frequency ranges.
•
Only use the device in countries in which it has been approved.
•
When reselling the device, inform the buyer about the regional approval restric‐
tions.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
Health hazards as a result of high-frequency electromagnetic radiation
The RMS3xx radar sensor is designed for operation in accordance with
ETSI EN 300440. During operation, the exposition limit values defined in EN 62311
must be upheld.
In order to limit human exposure to electromagnetic fields, suitable safety distances
must be maintained during both short-term and long-term work in the radiation range of
the antenna. The minimum distance between the antenna and the human body during
continuous operation is 20 cm.
Country-specific aspects which must be taken into account during operation of the
RMS3xx can be found in the RMS3xx "Regulatory Compliance Information" technical
information publication (no. 8021596), which is included with the product.
2.2
Improper use
Any use outside of the stated areas, in particular use outside of the technical specifica‐
tions and the requirements for intended use, will be deemed to be incorrect use.
•
The device does not constitute a safety component in accordance with the respec‐
tive applicable safety standards for machines.
•
The device must not be used in explosion-hazardous areas, in corrosive environ‐
ments or under extreme environmental conditions.
•
Any use of accessories not specifically approved by SICK AG is at your own risk.
2
SAFETY INFORMATION
6
O P E R A T I N G I N S T R U C T I O N S | RMS3xx
8021530/19JS/2021-02-09 | SICK
Subject to change without notice
