Important information
NOTICE
Loss of configuration data
Do not remove the memory card or switch off the supply voltage while the parameter
set is being saved. Otherwise all parameters not yet saved permanently will be lost.
Prerequisites
•
The supply voltage for the device is switched off.
Approach
Inserting the memory card
1.
Undo the screws on the hinged cover.
2.
Opening cover:
°
Carefully pull the upper edge of the cover away from the housing a little at the
level of the hinges on the side. Use both of the recesses on the inside of the
cover to do this.
°
Fold the cover upwards starting from the bottom edge.
3.
Making sure it is in the correct position, insert the memory card into the slot until
it locks into place. When doing this, position the contacts so that they are facing to
the rear and upwards, see the card symbol on the device.
4.
Close the cover again. Make sure that the cover is completely flush with the
housing.
5.
Re-tighten the screws on the cover.
6.
Switch on the supply voltage for the device.
Remove memory card
1.
Undo the screws on the cover.
2.
Making sure it is in the correct position, push the memory card into the slot until
it is released. When doing this, position the contacts so that they are facing to the
rear and upwards, see the card symbol on the device.
3.
Remove the memory card.
4.
Close the cover again. Make sure that the cover is completely flush with the
housing.
5.
Tighten the screws on the cover.
6.
Switch on the supply voltage for the device.
7.5
External data back-up
Data back-up options
The current parameter set can be manually saved and archived on the computer as
a project file (
*.sopas
file with configuration data). This is the generally recommended
procedure.
An additional external storage medium is required to automatically save the current
parameter set outside the device memory. The device is permanently connected to the
external storage medium for this purpose.
A microSD memory card with sufficient storage space can be used as the external
storage medium.
Access to the microSD memory card
The device does not directly signal access (read, write) to the memory card. The
MicroSD
status LED shows when the saving process is finished when permanently saving the
parameter set.
COMMISSIONING
7
8024289/1E1C/2022-09-09 | SICK
O P E R A T I N G I N S T R U C T I O N S | GLS621
35
Subject to change without notice
