Chapter
2
Online Help
Barcode Scanner CLV62x
8
©
SICK AG · Division Auto Ident · Germany · All rights reserved
8011967/S345/2008-04-23
CLV62x
2.2
Parameter
General
Activate/deactivate password protection via the parameters of the
group.
2.2.1
Reading configuration
Codelabel properties
The parameters of the
group are used to set the reading parameters
and the barcode properties.
Parameter
Function
Parameterisation is protected
by password
Activate/deactivate password protection.
If the password protection has been activated, the password
must be entered during login (password: "client").
The password cannot be altered.
Parameter
Function
Scan frequency
Select the recommended scan frequency for the respective read-
ing situation The scan frequency depends on the codelabel dis-
tance and the module width of the barcode. Also see the
frequency diagram in the operating instructions.
Quietzone ratio
Select ratio between quiet zone (white area before and after the
barcode) and the code's spaces.
Barcode quality
Select the average barcode quality. (Only deviates from the
"
S
TANDARD
" setting if the barcode has imperfections or is poorly
printed.)
Codelabel distance
Only for
P
HARMACODE
code types: Enter the distance between the
scanner and the barcode and select the unit.
Minimum reading angle
Enter the lower limit of the reading area.
0 = start of reading area
50 = middle of reading area
100 = end of reading area
Maximum reading angle
Enter the upper limit of the reading area.
0 = start of reading area
50 = middle of reading area
100 = end of reading area
Enable dynamic reading config-
uration
Activate/deactivate dynamic reading configuration.
The parameters of the
group can be gouped
into up to eight configurations.
The organization of the configurations is done on page
chapter 2.2.1.3 Dynamic reading configuration, page 10
.
