Sices GC250, Техническое руководство

Страница: 59 / 145

EAAM057608EN GC250 Technical Manual 59
o
(Flashing) Lack of Mains voltage.
o
(Flashing) Mains voltage present, but “out of tolerance” (low).
o
(Flashing) Mains
voltage present, but “out of tolerance” (high).
o
: Mains voltage present and “within tolerance”.

The status of the generator voltage (absent, low, high etc.)
o
: Lack of voltage on the generator.
o
: Generator voltage present, but “out of tolerance”(low).
o
: Generator voltage
present, but “out of tolerance”(high).
o
: Generator voltage present and “within tolerance”.

The status of the changeover:
o
: MCB circuit breaker closed.
o
: GCB circuit breaker closed.
o
: both circuit breakers open.

The possible presence of inhibitions to generator start.
o
: start allowed.
o
: start inhibited.
Some information are shown alongside an elapsing time; for example, during engine cooling
down, the residual time is shown.
7.4.6.2 S.02 ANOMALIES
The page S.02 is automatically displayed in case a new anomaly arises. For every anomaly,
it is shown:

A letter that identifies the type of it:
o
“A”: alarm (block)
o
“D”: deactivation.
o
“W”: warning.
•
A three digit numeric code that uniquely identify the anomaly. This code flashes until the
anomaly is acknowledged pressing any push-button.
•
A symbol that identifies the anomaly, see par. 10.5, 10.6 and 10.7.
Every fault uses one or two rows of the LCD display. The fault shown in the highest position
is the most recent, chronologically. If space is not sufficient to show all the pending anomalies,
only the most recent ones are shown. In order to see the others, it is required to:
o
Press and keep press the button
▼.
o
Use the ▲▼ push-buttons to scroll the anomalies.
o
At the end Press and keep press the button ▲.