Sices GC250, Техническое руководство

Страница: 122 / 145

122 GC250 Technical Manual EAAM057608EN
time configured, but only after the time P.0216 (oil mask) from engine start has elapsed (this
is to allow you to ignore the normal status of low pressure, which occurs at start-up).
42 Minimum oil pressure (from analogue sensor)
Icon:
Type: Alarm
Category: Engine protection
Related parameters: P.4017 Function for analogue input T.14 (OP) or equivalent
parameter for other inputs
P.0216 Time for engine protection mask
P.0341 Threshold for minimum oil pressure
P.0342 Delay for minimum oil pressure
P.0700 Engine type
To disable: P.0342=0
This protection is enabled only if the controller acquires the measure of the engine lubrication
oil pressure. It can acquire it from its input T.14 (with P.4017 suitably configured) or from CAN-
BUS (P.0700 other than zero). It is only enabled if the controller has been started by the
controller (if the command for the fuel solenoid is activated) and is disabled in the engine
start/stop phases. It activates if the pressure is continuously lower than or equal to threshold
P.0341 for time P.0342, but only after the time P.0216 (oil mask) from engine start has elapsed
(this is to allow you to ignore the normal status of low pressure, which occurs at start-up).
43 Low oil pressure (from contact)
Icon:
Type: Warning
Category: Engine protection
Related parameters: P.2001 Function of input T.16 or equivalent for other inputs
P.2002 Delay for input T.16 or equivalent for other inputs
P.0216 Time of engine protection mask
To disable: P.2002=0
Enabled in: MAN, AUTO, TEST, REMOTE START
This protection is enabled only when one of the digital inputs of the controller is configured to
acquire the external low oil pressure contact (feature DIF.4222 -
“Low oil pressure” in
parameter P.2001 or equivalent for the other inputs) and if a time other than zero has been
set for said input (parameter P.2002 or equivalent). It is only enabled if the controller has been
started by the controller (if the command for the fuel solenoid is activated) and is disabled in
the engine start/stop phases. It activates if the input config
ured is continuously “active” for the
time configured, but only after the time P.0216 (oil mask) from engine start has elapsed (this
is to allow you to ignore the normal status of low pressure, which occurs at start-up).
44 Low oil pressure (from analogue sensor)
Icon:
Type: Warning
Category: Engine protection
Related parameters: P.4017 Function for analogue input T.14 (OP) or equivalent
parameter for other inputs
P.0216 Time for engine protection mask
P.0339 Threshold for low oil pressure