Shuttle HOT-675, Руководство пользователя

Страница: 40 / 50

- 40 -
If you have equipped your system with a PCI controller, changing this allows you to
specify which slot has the controller and which PCI interrupt (A, B, C or D) is associ-
ated with the connected hard drives.
Remember that this setting refers to the hard disk drive itself, rather than individual
partitions. Since each IDE controller supports two separate hard disk drives, you can
select the INT# for each. Again, you will note that the primary has a lower interrupt
than the secondary as described in "
Slot x Using INT# " above.
Selecting " PCI Auto " allows the system to automatically determine how your IDE disk
system is configured.
Assign IRQ for USB
This item allows the user to assign IRQ to on-board USB controller or not.
Since on-board controller is enabled always, if none of IRQ is assigned to it, there will be
a question mark report on system device under windows 95.
PCI Latency Timer
The number of clocks programed in the PCI Latency Timer represents the guaranteed
time slice allocated to the 440LX, after which it must complete the current data transfer
phase and surrender the bus as soon as its bus grant is removed.
The PCI Latency Timer is used to guarantee to the PCI agents a minimum amount of the
system resource.
The default setting is 64 PCI clocks.
MS IRQ Routing Table
This item allows the user to set BIOS IRQ Routing Table Enabled or Disabled.