Shure Advance MXA310, Руководство пользователя

Страница: 38 / 55

Shure Incorporated
38/55
•
•
•
•
•
•
•
•
•
•
•
◦
◦
◦
◦
1.
2.
3.
4.
5.
Important: For encryption to work:
All Shure devices on your network must use encryption.
Disable AES67 in Dante Controller. AES67 and AES-256 cannot be used at the same time.
If you’re using Shure Designer software to configure your system, please check the Designer help section for more about this topic.
Mute Synchronization
Mute synchronization ensures that all connected devices in a conferencing system mute or unmute at the same time and at the
correct point in the signal path. Mute status is synchronized in the devices using logic signals or USB connections.
To use mute synchronization, enable logic on connected devices using the web application or Shure Designer software. Many
Shure devices have logic enabled automatically.
If you use Designer's Optimize workflow, Designer configures all of the necessary mute synchronization settings for you.
Shure logic devices:
P300 (Also mutes supported soft codecs connected by USB)
ANIUSB-MATRIX (Also mutes supported soft codecs connected by USB)
MXA910
MXA710
MXA310
Network Mute Button
ANI22-BLOCK
ANI4IN-BLOCK
Logic-enabled MX microphones connected to ANI22-BLOCK or ANI4IN-BLOCK
MX392
MX395-LED
MX396
MX405/410/415
Setting Up Mute Sync on the MXA310 and P300
Use this setup to mute the P300 by pressing the mute button on the MXA310. In the P300’s signal chain, muting happens after
the DSP so that the AEC stays converged.
Open the P300 in Designer and go to Inputs.
On any channel strip, select Logic enable. This enables logic on all channels.
Open the MXA310 in Designer and go to
Settings
>
Logic control
.
Set the Mute control function to Logic out.
Go to Lights. Set the style to Ring.
Automix Channel
This channel automatically mixes the audio from all channels to deliver a convenient, single output. The automix channel must
be routed in Dante Controller to the desired output.
Note: Automix is disabled when using the toroid polar pattern. Inversely, the toroid pattern cannot be selected when automix is enabled.