SHUR-DRI SD-100-01, Руководство по установке

Страница: 7 / 36

For parts or assistance, call Shur-Dri Customer Service at 1-800-535-4950
Installation 7
Process C. 2. Install a deep well
pump
DEEP WELL PUMP INSTALLATION
(4" DIAMETER CASED WELL)
For wells over 25, but not exceeding 70 feet in depth, the 1 HP
Convertible Deep Well Pump is recommended. However, the
1/2 HP Deep Well Pump may also be used for depths not
exceeding 70 feet.
General materials needed for either of the convertible
pumps:
• One can PVC cement (read instructions carefully)
• One can thread compound (read instructions carefully)
• Two 1" female PVC adapters
• Enough rigid 1-1/4" PVC pipe and couplings to reach from
bottom of well to pump (delivery pipe)
• One 1-1/4" PVC elbow
• One 1-1/4" male PVC adapter
• One pressure regulator Kit (includes fittings, tubing, and
1/4" plug)
• One pressure gauge
• Two male 3/4" PVC adapters
• Enough rigid 3/4" PVC pipe to reach from pump to
pressure tank to service line
• Tank tee (for diaphragm pressure tanks)
• Two 1/4" plugs
• One 1/2" drain cock
In addition to General Materials:
• One 1-1/4" foot valve
• One 1-1/4" close nipple
• One FP520-100 ejector kit
• One 1" x 5" nipple
• One 1-1/4" female adapter
• One well seal
• Enough rigid 1" PVC pipe and couplings to reach from
bottom of well to pump (pressure pipe)
• One 1" PVC elbow
• Two 1-1/4" male PVC adapters
• One 1" x 4" nipple
REMINDER: ALL JOINTS AND CONNECTIONS MUST BE AIRTIGHT. A SINGLE PINHOLE
LEAK WILL PREVENT THE PROPER OPERATION OF THE PUMP. USE THREAD
COMPOUND ON ALL THREADED CONNECTIONS UNLESS SPECIFIED OTHERWISE.
1. Thread 1-1/4" close nipple into foot
valve. Thread the other end of 1-1/4"
close nipple into bottom of deep well
ejector. Hand tighten, then tighten
1/4 turn with pipe wrench.
2. The ejector has two holes in the top
of it. Thread deep well venturi tube
(part #2 – longer tube) into larger
hole until snug. Thread 1" x 5" nipple
into smaller hole. Only hand tighten
venturi tube. Hand tighten nipple 1/4
turn with pipe/crescent wrench.
1-1/4"
CLOSE
NIPPLE
EJECTOR
FOOT
VALVE
EJECTOR
VENTURI
TUBE
1" X 5"
NIPPLE
TO INSTALL THE CONVERTIBLE
3. Thread a 1-1/4" male PVC adapter
over the venturi tube and into
ejector. Thread a 1" female PVC
adapter onto the 1" x 5" nipple.
Hand tighten adapters 1/4 turn with
pipe/crescent wrench.
1" FEMALE
PVC
ADAPTER
1-1/4" MALE
PVC
ADAPTER
4. Subtract five feet from the depth
of your well. This is the total length
of PVC pipe and couplings to
cement onto both 1-1/4" male and
1" female PVC adapters. Cement
a section of PVC pipe to each
adapter, then lower the whole
assembly into the well, foot valve
first. Firmly clamp the end of the
PVC pipes with a pipe clamp to prevent the assembly from
sliding down into well.
1" FEMALE
PVC
ADAPTER
1-1/4" MALE
PVC
ADAPTER