SHOWTEC Stage Blinder 4 Blaze, Руководство пользователя

Страница: 13 / 32

12
Ordercode: 30781
Stage Blinder 4 Blaze
The Stage Blinder 4 Blaze can be operated with a controller in control mode or without the controller in
stand-alone mode.
Control Panel
A) OLED display
B) UP button
C) MODE button
D) DOWN button
E) SET button
Fig. 05
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Stage Blinder will respond to the controller.
Please note when you use the controller, the unit has 16 channels.
When using multiple Stage Blinders, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Stage Blinder should be 1(001); the DMX address of the second
Stage Blinder should be 1+16=17 (017); the DMX address of the third Stage Blinder should be 17+16=33
(033), etc. Please, be sure that you do not have any overlapping channels in order to control each Stage
Blinder correctly. If two or more Stage Blinders are addressed similarly, they will work similarly.
Controlling:
After having addressed all Stage Blinder fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Stage Blinder will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX input, the problem may be:
●
The XLR cable from the controller is not connected with the input of the Stage Blinder.
● The controller is switched off or defective, the cable or connector is defective, or the signal wires are
swapped in the input connector.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 30 seconds
When no button is pressed for 30 seconds, the display will turn off.
To light up the display, you have to press the MODE, SET, UP or DOWN button.
Once you have pressed the button, the display will light up.